LSI Mylex PCI Disk Array Controllers Driver, Installation Manual

Page: 74 / 104

Installing the Controller as the Secondary UnixWare Controller with UnixWare 7.1
6-4 PCI Disk Array Controller Drivers Manual
• Insert the Software Kit UnixWare (dak) driver diskette as instructed,
and continue with the instructions provided in the UnixWare
Installation Handbook.
• The controller should be detected automatically during the install
process.
5. After the installation of boot files, the system is automatically shut
down.
Use /dev/rct0 and /dev/cdrom/c0b0txl0 (x is the CD-ROM SCSI ID
number) to access tape and CD-ROM devices after installation.
Installing the Controller as the Secondary
UnixWare Controller with UnixWare 7.1
If UnixWare is installed on a Mylex controller, the Mylex Disk Array
Controller driver for UnixWare is already installed in the system. Simply
install the new Mylex Disk Array Controller hardware.
If UnixWare is installed on a non-Mylex controller, install the Mylex Disk
Array Controller driver for UnixWare as follows:
1. Insert the Software Kit UnixWare (dak) driver diskette into the floppy
diskette drive, please refer to “Creating a Driver Diskette for
UnixWare” on page 6-3.
2. Type the following (match case exactly as shown):
pkgadd -d diskette1 dak
↵
The new controller driver is installed.
3. Rebuild the Kernel:
/etc/conf/bin/idbuild -B
↵
4. Reboot the system:
shutdown -i0 -g0 -y
↵