R-Log – Quick Start
Cod. INSTUM_00953
Pag. 14
3.3.
Creating a configuration report
The
Configuration Report
contains all information concerning the configuration under consideration
including indications on how to connect the different probes to the instrument terminals:
Open the configuration under consideration;
Press the
Report
key on the Instrument bar;
Press
OK
on
Measures Order
;
Assign a name to the file by setting the save path.
If some measures have no connection assigned, a possible cause could be that the measure was
created without using the LSI LASTEM sensors registry.
It is recommended to print the document in order to be able to use it later when connecting the
probes to the datalogger.
3.4.
Connecting the probes
It is recommended to connect the probes with the instrument turned off.
3.4.1.
Electrical connection
For ELR516M and ELR515 models.
The probes should be connected to the datalogger inputs that were assigned with 3DOM. For this
reason, connect the probe to the terminal box as follows:
Identify the terminals to be used with the probe under consideration in the
Configuration
Report
;
Check for the congruence of the colors indicated in the
Configuration Report
with those
reported in the probe accompanying design; in case of discordances, refer to the probe
accompanying design.
Failing information, refer to the tables and schemes below.
TERMINAL BOARD
Analogue
input
Signal
GND
Actuator
A
B
C
D
Number
+V
0 V
1
1
2
3
4
7
1
5
6
2
17
18
19
20
3
8
9
10
11
23
2
21
22
4
24
25
26
27
