UNITOUR Power System
User Manual
Page 48
4
Emergency Mode
In the unlikely event that the UNITOUR does not respond to commands, you can manually
force the any output channel into the ON state.
WARNING.
Use this method of turning on a channel only as a last resort. LSC Control Systems takes no
responsibility for any damage this might cause to connected equipment because the protection
systems of the UNITOUR are disabled in this mode. The following action will turn the channel
on, even if the system has shut down the output due to a dropped neutral or over voltage
input.
To force a channel into the EMERGENCY ON state, press and hold its channel
SELECT
button for more than 10 seconds.
To force an EMERGENCY ON channel into the OFF state, press and hold its channel
SELECT
button for 1 second.
Note: EMERGENCY mode works for all channels, even channels set to ALWAYS OFF.
“
Emergency Mode
”
Press and HOLD for
more than 10
seconds to force the
channel ON
