LS SV-iG5H Series, Manual, Page: 42 / 226

28
Programming Keypad & Basic operation
4.5 Parameter setting
Changing parameter values in Drive Group

When changing ACC time from 5.0 sec to 16.0 sec
1
In the first code “0.00”, press the Up (

) key once to go to the

second code.
2
ACC [Accel time] is displayed.

Press the Ent key (

) once.

3
Preset value is 5. 0 , and the cursor is in the digit 0 .

Press the Left (

) key once to move the cursor to the left.

4 The digit 5 in 5 .0 is active. Then press the Up (

) key once.

5
The value is increased to 6 .0

Press the Left (

) key to move the cursor to the left.

6
0 .60 is displayed. The first 0 in 0 .60 is active.

Press the Up (

) key once.

7
1 6.0 is set.

Press the Ent (

) key once.

1 6.0 is blinking.

Press the Ent (

) key once again to return to the parameter

name.
8
ACC is displayed. Accel time is changed from 5.0 to 16.0

sec.
♣
In step 7, pressing the Left (

) or Right (

) key while 16.0 is blinking will disable the
setting.
Note
Pressing the Left (

)/ Right (

) /Up (

) /Down (

) key while cursor is blinking will cancel
the parameter value change. Pressing the Enter key (

) in this status will enter the value
into memory.