Easy Start Guide
12. How to reset the Inverter to Factory Defaults
Page 13
This guide has been produced by The Inverter Drive Supermarket Ltd.
All content, including but not limited to graphics, text and procedures copyright
The Inverter
Drive Supermarket and must not be reproduced or altered without prior written permission.
©
12.1 Use the navigation pad to navigate to parameter
H93.
From the home screen, press the right arrow on the
navigation pad twice to move to Parameter function group 2
“H”.
Then, press the down arrow three times to navigate to
“H93".
Note: If you are unsure if the display is showing the home
screen, power-off the iC5 for 60 seconds before switching
back on.
12.2 Press the navigation pad to change the value of
parameter H93.
Once the display shows “H93", press the navigation pad to
select the parameter and edit it’s value.
The display will show the default value of “0".
12.3 Press the up arrow on the navigation pad to
change the value from 0 to 1.
Press the up arrow on the navigation pad once to change
the value of H93 from 0 to 1.
Press the navigation pad to save the changes. The display
will flash to indicate that the change needs to be confirmed.
Press the navigation pad again to confirm the change. The
display will return to H93.
All parameters have now been reset to factory defaults.
NPN
PNP
RUN
STOP/RST
FWD
REV
min
max
NPN
PNP
RUN
STOP/RST
FWD
REV
min
max
NPN
PNP
RUN
STOP/RST
FWD
REV
min
max
LS Industrial Systems SV-iC5