LS Mecapion L7 A001, User Manual

Page: 99 / 222

4. Parameters
4-45
4.2.8 Operation Handling Parameter
“**” Modification is not possible with the servo on & Power reset parameter.
“*” Parameter that cannot be modified with the servo on
Parameter Unit Initial
Details
Code Name Minimum Maximum
Cn-00
Manual JOG operation - - The drive performs manual JOG operation
by itself.
(Refer to “Chapter 5 Handling and
Operation.”)

[MODE]: Finish

[UP]: Forward rotation (CCW)

[DOWN]: Reverse rotation (CW)

[SET]: Servo ON / OFF
Related parameters are as follows:

[P3-08]: Speed command acceleration
time

[P3-09]: Speed command deceleration
time

[P3-10]: Speed command S-curve

[P3-11]: Speed operation pattern

[P3-12]: JOG operation speed
Operate regardless of the contact input
status of CN1.
(Details: Refer to “4.4.5 Speed Operation
Parameter
Setting.”)
(Details: Refer to "5.2 Handling.")
Jog - -
Cn-01
Program JOG operation - - Continuously operates according to the
program already set.

[SET]: Program JOG run or stop
Related parameters are as follows:

[P3-08]: Speed command acceleration
time

[P3-09]: Speed command deceleration
time

[P3-10]: Speed command S-curve

[P3-11]: Speed operation pattern

[P3-13~16]: Program operation speed 1
to 4

[P3-17~20]: Program operation time 1 to
4
Operate regardless of the contact input
status of CN1.
(Details: Refer to “4.4.5 Speed Operation
Parameter
Setting.”)
(Details: Refer to "5.2 Handling.")
Program jog
- -
Cn-02
Alarm reset - -
Reset the alarm that went off.
(Details: Refer to "5.2 Handling.")
Alarm reset - -