LS Mecapion L7 A001, User Manual

Page: 104 / 222

4. Parameters
4-50
5. Torque limit [St
–11]
Displays the maximum torque that the servo motor can output as a percentage of the rated torque.
6. DC link voltage [St
–12]

The DC link voltage of the standard drive that uses 220 [V] is approximately 300 [V].

The maximum DC link voltage allowed for the standard drive that uses 220 [V] is 405 [V].

The overvoltage alarm [AL-41] triggers when the DC link voltage threshold is exceeded because
there is either too much or too little regenerative resistance.

The normal DC link voltage in the regenerative section is 385 [V] or below.
7. Regenerative overload [St
–13]
Displays overload rate relative to the regenerative capacity of the servo drive.
4.3.5 I/O Status Display
1. CN1 I/O input contact point status [St-14]
Refer to "4.1.4 External Input Contact Point Signal Display [St-14]."
2. CN1 I/O output contact status [St-15]
Refer to "4.1.6 External Output Contact Signal Display [St-15]."
4.3.6 Miscellaneous Status and Data Display
1. Single-turn data (pulse) display [St-16]
Displays the single-turn data of the encoder in pulses.
2. Single-turn data (degree) display [St-17]
Displays the single-turn data of the encoder in degrees.
3. Multi-turn data display [St-18]
Displays the multi-turn data of the encoder.
4. Inside temperature display [St-19]
Displays the temperature sensor value of the servo drive in [
℃
].
5. Rated motor speed display [St-20]
Displays the rated speed of the currently installed motor in [RPM].
6. Peak motor speed display [St-21]
Displays the peak speed of the currently installed motor in [RPM].
7. Rated motor current display [St-22]
Displays the rated current of the currently installed motor in [A].
8. U phase current offset display [St-23]
Displays the U phase current offset in [mA].
9. V phase current offset display [St-24]
Displays the V phase current offset in [mA].