Chapter 6 Instruction Details
XBC E-Type Main Unit
6-52
Ver. 1
6.13 Output Instruction
6.13.1 OUT, OUT NOT, OUTP, OUTN
Instruction
Area Available
Step
Flag
P M K F L T C S Z D.x R.x
Co
nst.
U N D R
Error
(F110)
Zero
(F111)
Carry
(F112)
OUT
OUT NOT
D O O O - O -
-
-
- O O - O -
-
-
1/2
-
-
-
OUTP
OUTN
D O O O - O -
-
-
- O O - O -
-
-
2
-
-
-
Operand
Description
Data Type
D
Contact to be On/Off / Word device’s bit contact.
BIT
1) OUT, OUT NOT
(1) OUT is used to output operation result of OUT Instruction as it is in specified device.
(2) OUT NOT is used to output reversed operation result of OUT NOT Instruction in specified device.
(3) Refer to 8.6 Subsequent Input Sequence Preferred Instruction for details on OUT Sxx.yy.
2) OUTP, OUTN
(1) For OUTP, when up to OUTP Instruction operation
result changes Off → On, specified contact is On for 1
scan and then it will be Off. If specified contact is of word device’s bit contact, applicable bit will be 1 only for
1 scan and then it will be 0.
(2) For OUTN, when up to OUTN Instruction operation result changes On
Off, specified contact is On for 1
scan and then it will be Off. If specified contact is of word device’s bit contact, applicable bit will be 1 only for
1 scan and then it will be 0.
(3) Master-K’s D, D NOT Instruction is the Instruction changed.
OUT D
OUT NOT D
OUTP D
OUTN D
/
P
N
Summary of Contents for XBC-DN10E
Page 1: ......
Page 10: ...Table of Contents Table of Contents 6 10 10 CLEAR ALL PLC 29...
