LS ELECTRIC LSLV-H100 Series, User Manual

Page: 258 / 618

245
Learning Advanced Features
Code Description
inverter heat sink temperature is higher than its set
value, the cooling fan operates automatically
regardless of its operation status.
1 Always On Cooling fan runs constantly if the power is supplied to
the inverter.
2 Temp
Control With power connected and the run operation
command on: if the setting is in Temp Control, the
cooling fan will not operate unless the temperature in
the heat sink reaches the set temperature.
Note
Despite setting ADV-
64 to ‘0 (During Run)’, if the heat sink temperature reaches a set level by
current input harmonic wave or noise, the cooling fan may run as a protective function.
A capacity of 110 kW or more has a small built-in fan installed to cool the internal temperature.
The internal fan controls on / off in conjunction with the operation command of the inverter main
control fan
5.33 Input Power Frequency and Voltage Settings
Select the frequency for inverter input power. If the frequency changes from 60 Hz to 50 Hz,
all other frequency (or RPM) settings, including the maximum frequency, base frequency,
etc., will change to 50 Hz. Likewise, changing the input power frequency setting from 50 Hz
to 60 Hz will change all related function item settings from 50 Hz to 60 Hz.
Group Code Name LCD Display Parameter Setting Setting Range Unit
BAS 10 Input power frequency 60/50 Hz Sel 0 60 Hz 0
–1
-
Set Inverter input power voltage. Low voltage fault trip level changes automatically to the
set voltage standard.
Group Code Name LCD Display Parameter Setting Setting Range Unit
BAS 19
Input
power
voltage
AC Input
Volt
200 Type 220 170
–240
V
400 Type 380
320
–480 0.75~90kW
320-550 110~500kW