MultiController E 0-100%
LS Control A/S
Side 5
2.3
Quick Set-up
When the MultiController is first connected to supply it must be chosen how it should function. First language is
chosen and then the wanted quick setting (01-06).
Operating parameters are set for a standard setting. New quick setting can be performed by returning to factory
setting (D4) and start over. Operating parameters can be adjusted through the menus in the MultiController.
Set-up
Description
01
ON/OFF
Shift between 2 levels (low/high). Both voltage levels are adjustable, e.g. 0.0/10V, 3.5/8.0V
etc. Pres ‘Enter’ to shift between the levels or let the build-in scheduler determine the shifts.
Relay output is closed at ”ON”.
02
0-100%
Stepless adjustment by pressing “Arrow Up” and “Arrow Down”. The integrated scheduler
function can be set to shift amongst 3 different operating levels; Stop, Normal Setpoint or
Alternative Setpoint. Relay output is closed when voltage level is higher than selected value
(factory setting is 0.1V, i.e. the relay operates as an operation relay).
03
0-100% PIR
As set-up 02, but instead of using the scheduler function a PIR (motion) sensor is connected
to shift between Normal and Alternative Setpoint*.
When choosing PIR in set-up, the possibility of using the scheduler function is deactivated.
04
0-100% Tacho
As set-up 02. And monitoring EC-motors Tacho-signal (rotation guard). Displaying alarm
text if tacho signal becomes absent.
05
4-Step
For controlling in 4 predefined fixed steps. (Each step is user defined).
06
2-Step PIR
Shifts between 2 operating levels* via a connected PIR (motion) sensor.
*
Or shift between stop and an operation level.
Set-up 01 (ON/OFF), 02 (0-100%),
Set-up 04 (0-100% Tacho)
03 (0-100% PIR), 05 (4-step) and
06 (2-step PIR):
