10
SEAT/FLOOR HEIGHT
1. Determine if the seat needs to be
raised or lowered.
2. Tip the chair backwards until the
push bar rests on the floor.
The height adjustment (from 16
"
to 21
"
) is done according to the length
of the user’s lower leg. It is important to have hips, knees and ankles at
90 degrees. The patient’s feet must make good contact with the floor.
3.
Using a ½" (13 mm) wrench,
remove the 4 bolts (2 per side)
that hold the seat support.
4. Position the seat bracket at the
desired height. MAKE SURE BOTH
SIDES ARE AT THE SAME LEVEL.
Put back the 4 bolts without
forgetting the flat washers and the
lock washers. Tighten properly.
5. Put the chair back on its wheels and have the user try it, to ensure that
the feet have sufficient contact with the ground for self-movement.
Readjust if needed.
ADJUSTMENT AND OPERATING
INSTRUCTIONS
Summary of Contents for Evolution S-250
Page 28: ...28 VUE CLAT E EXPLODED VIEW...
Page 29: ...29...
