INSTALLATION
Translation of the original instructions
14
3.5
Water connection and drainage
To limit the temperature on the floor, we recommend connecting the drop-in to the water supply (see
installation drawing and technical data table). It is also advisable to install a shut-off valve upstream of the
appliance.
The drainage pipe must be connected to a suitable, legally compliant drain.
It is recommended that the pipeline be connected in such a way as to avoid bottlenecks or siphons. Water is
discharged by free fall, so it is essential that the height of the drain is lower than the point of exit of the pipe.
The water discharge pipe also conveys cooking fat. If the drain is not connected, the installer must either
plug the drain hole or direct the cooking fat into a collection drawer.
Starting up
Before using the appliance, it must be carefully cleaned (see section "Cleaning and care"). Check the water
connection of the appliance and put it into operation according to the instructions below Caution: - Use the
appliance only under supervision.
Water load
Check that the drain cock lever is in the closed position.
Caution
Keep the exhaust filter clean
