MAINTENANCE
Translation of the original instructions
32
6.4
Replacing the grill burner nozzle
To replace the nozzle, unscrew the securing screws (see fig. D), move the burner to the right and release it,
unscrew the nozzle (2) using a suitable wrench and replace it (see "Technical data" table). Set the air
adjustment bush (4) to the corresponding value in the "technical data" table by unscrewing the locking screw
complete with locknut.
Note
No minimum adjustment is needed since the burner only operates with a fixed flame
6.5
Replacing the oven lamp
·
Cut of the power supply
·
Remove the glass cap on the lamp holder
·
Unscrew the lamp bulb
The new lamp bulb must have the following characteristics:
·
Resistance to heat up to 300 °C
·
Power 15W
·
Voltage 230V 50Hz
6.6
Minimum setting
·
After conversion to use another type of gas, or if a flame is too high when the knob is in position
(
small flame), adjust the minimum setting by turning the by-pass screw. For operation with LPG, the
by-pass must be completely closed; for operation with natural gas, it must first be closed and then
opened by 1/4 turn
