Lotus ATS-1000, User Manual

Page: 26 / 30

26
10
Installation Manual and Operating Instructions
TROUBLE SHOOTING
Trouble Cause Remedy
The water does
not spray
The unit is not
operating
Water is leaking
Water pressure
is weak
Water is not
warm
The seat and
dryer is not
warm
1. The water tank is not filled.
2. The shutoff valve is closed.
3. Freezing inside the main unit
or the water supply pipe. 1. Wait about one minute.
2. Press the desired washing
button once again.
3. Turn on the shutoff valve to
open.
4. Heat the room (for about two
hours). Operating the unit while
parts are frozen will cause a
malfunction.
1. Disconnected the power cord.
2. The seat is not occupied.
3. The battery of remote
controller is exhausted.(Only
ATS-1000L/R model)
1. Connect the power cord.
2. Check the power supply
system in your house.
3. Occupy the seat (It does not
operate unless occupied).
4. Replace the battery. (Only
ATS-1000L/R model)
1. Check the water supply system
1. If water is leaking from the main
unit, call the service center or the
place you purchased.
1.The water pressure level is set
to“LOW”.
2. The strainer is clogged.
1.Set the water pressure
to“HIGH”.
2. Clean the strainer.
1. The water temperature is set
to“LOW”.
2. Continuous operation has
depleted the supply of warm
water.
1.Set the water temperature
to“HIGH”
2. Wait about three minutes.
1.The seat & dryer temperature is
set to “LOW”
1. Set the seat & dryer temperature
to “HIGH”.
MAINTENANCE
( ) ( )
( )
( )
( )
( )