2. The PTZ controls open. Click
to open advanced PTZ controls, then click
.
3. Click the
Preset
tab.
4. Enter the number of the preset you want to create under
Preset
.
5. Move the camera to the desired position and click
Set
.
To go to a preset location:
• Under
No.
, select the number of the preset you want to go to, then click
.
20.5 Tours
Tours will cycle through a set of presets.
To add tours:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click
Pan/Tilt/Zoom
.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click
.
3. Click the
Tour
tab.
4. Under
Patrol No.
, enter the number of the tour you want to create.
5. Under
Preset
, select a preset you want to add to the tour.
6. Click
Add Preset
.
7. Repeat steps 5 & 6 to add additional presets to the tour.
To run a tour:
• Under
No.
, select the number of the tour you want to go to, then click
.
20.6 Patterns
Patterns automatically move the camera according to manually-entered movements.
To add patterns:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click
Pan/Tilt/Zoom
.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click
.
3. Click the
Pattern
tab.
4. Under
Pattern
, enter the number of the pattern you want to create.
5. Move the camera to the desired starting position, then click
Start
.
6. Using the on-screen controls, move the camera in any pattern you wish. When finished, click
End
.
To run a pattern:
• Under
No.
, select the number of the pattern you want to go to, then click
.
20.7 AutoScan
An autoscan automatically cycles between a left and right point.
To configure autoscan:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click
Pan/Tilt/Zoom
.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click
.
3. Click the
Border
tab.
4. Move the camera into the desired left position and click
Left
.
5. Move the camera into the desired right position and click
Right
.
#LX400113; r. 9.0/57192/57197; en-US
96