www.lorextechnology.com
LW1741AC1_QSG_TRILINGUAL_R1
Page 1
ADD-ON CAMERA
LW1741AC1
QUICK START GUIDE
lorextechnology.com/support
x1
x3
x1
Attach the camera stand to the camera.
2
1
Use the included mounting screws to attach the
camera stand to the mounting surface:
a. Mark the positions of the screw holes on the mounting surface with
the base of the mounting stand.
b. Drill holes and insert the drywall anchors (included) as needed.
c. Firmly attach camera stand to the surface using the included screws.
Camera Setup
Before installing the camera, carefully plan where and
how it will be positioned, and where you will route the
cable that connects the camera to the power adapter.
4
Connect one end of the camera’s power adapter to
the camera and the other end to an electrical outlet.
Make sure the power connector is fully inserted to
avoid water getting in the plug.
5
Remove the protective film from the front of the
camera. If the film is not removed, it will affect
picture quality.
• Camera is rated for indoor/outdoor installation, but is not intended
for direct exposure to rain or snow. For outdoor applications, install
under shelter protected from the elements.
• Wireless cameras require a power source to operate.
• Ensure power outlets are sheltered from the elements.
Installation Tips
NOTE:
If you run the power cable through the mounting surface,
connect power before attaching the camera to the wall.
Press
on the receiver to enter the main menu.
2
1
Connect the new camera
to a power outlet. Place the
camera within 1ft of the
wireless receiver.
Pairing the Camera with the Receiver
3
Select
Camera Setting
and press
OK
to confirm.
What’s Included
6
NOTE:
If you pair a new camera to a channel that is already being
used by an existing camera, the new camera will be connected to
that channel. The old camera will automatically be disconnected.
Following the on-screen prompt,
you have 30 seconds to press
the
Pair
button on the camera.
If pairing was successful, the pairing
channel shows the statement
PAIR OK
.
NOTE:
If you do not press the
Pair
button on the camera during
the 30 second pairing window, repeat steps 2~6 to try the pairing
process again.
NOTE:
If the speaker begins squealing, move the camera and
receiver away from each other.
1ft
OK
Pair
Pair
Press
repeatedly to return to live view to see the camera’s video
feed displayed on-screen.
OK
4
Select
Pairing
and press
OK
to
confirm.
5
Use the arrow keys on the receiver to
select the channel you want to pair
the camera to. Press
OK
on the
desired channel to begin pairing.
3
Loosen the adjustment ring
on the metal camera stand
and move the camera to the
desired position.
Tighten the adjustment ring
when finished, holding the
camera firmly in position.
Adjustment ring
