To add patterns:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click
Pan/Tilt/Zoom
.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click
.
3. Click the
Pattern
tab.
4. Under
Pattern
, enter the number of the pattern you want to create.
5. Move the camera to the desired starting position, then click
Start
.
6. Using the on-screen controls, move the camera in any pattern you wish. When finished, click
End
.
To run a pattern:
• Under
No.
, select the number of the pattern you want to go to, then click
.
17.7 AutoScan
An autoscan automatically cycles between a left and right point.
To configure autoscan:
1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then
click
Pan/Tilt/Zoom
.
2. The PTZ controls open. Click
to open advanced PTZ controls, then click
.
3. Click the
Border
tab.
4. Move the camera into the desired left position and click
Left
.
5. Move the camera into the desired right position and click
Right
.
To run autoscan:
• Click
.
#LX400111; r. 2.0/56089/56100; en-US
86
