Lorenz COMPACT 8 SUN, User Manual

Page: 74 / 114

76 User Manual
When Slave mode is set, the chart plotter cannot manipulate the C-Link
navigation data anymore.
Stop current navigation
If the navigation was already active, it will be disabled as soon as Slave mode is set.
An appropriate warning message will be shown to notify that the Navigation is
already active and to confirm whether Slave mode can be set.
Inhibit Navigation operation
As soon as Slave mode is set, the destination cannot be placed anymore either the
C-Link navigation data is received from the Master or not. Also, when the C-Link
navigation data is received from the Master, it will not be allowed to deactivate the
Navigation.
Inhibit Route following
While navigating to the route received from the Master the destination is reached
(either applying distance or perpendicular criteria), the destination will not be moved
to the next Waypoint on the route.
MOB handling
If the Navigation to the external destination is active and the MOB key is pressed on
the Slave Chart Plotter, the MOB is placed but the navigation to the MOB is not
activated.
Notes
While navigating to the external destination the Operating Mode is switched to Master
mode, the navigation to the external destination will be terminated. An appropriate
warning message will be shown to notify that the Navigation to the external destina-
tion is active and to confirm whether Slave mode can be set. Setting Slave mode,
the C-Link navigation data will be deleted.
The C-Link navigation data are deleted at Power Off.
4.7.1.5 C-Link navigation data: Acquisition and Display
As soon as the C-Link navigation data is received, the Slave parses the informa-
tion received and executes the relative actions depending on its current working status.
Important
When the Navigation to the external Destination is activated, the Slave Chart Plotter will show all
relevant C-Link navigation data exactly like when the destination is not the external one:
(Destination Name, DST and BRG to Destination, calculate XTE, calculate TTG etc). These values
will be displayed all places where required and they will be used to format NMEA-0183 output data.