page 62
Reading out machine data
Since the software version 1.12 from the 30th November 2015 it is possible to read out machine data using a
smartphone. Depending on the existing front panel the data can be transferred with different methods:
front panel
read out via
Basic, BasicPlus NFC
ControlPro
NFC, QR-code
The following data can be read out:
- software versions
- information- and error messages
- operating hour counters
-
machine configuration
- actual settings and welding parameters
Read out via NFC
A smartphone with NFC functions is required. To read out the data follow these steps:
Basic/BasicPlus:
-
switch off the machine
- press the menu button (upper-left button) and keep it pressed
- switch on the machine
- release the menu button
ControlPro:
-
switch off the machine
- press the menu button A50 and keep it pressed
- switch on the machine with the button pressed
- release the menu button A50
The machine shows “nFc Act” at the front panel.
In this condition a smartphone with NFC functions must be held to the front panel. The
machine transfers the data to the smartphone and accesses a Lorch web site automati-
cally that displays the data:
The email address of the user/technician can be put into the field “E-Mail” and hit the
button “Send E-Mail”. A PDF with the data is then send to the e-mail address that was
entered.
Summary of Contents for MicorMIG 300
Page 1: ...Service Manual MicorMIG 909 2130 1 10 ...
Page 35: ...page 35 ...
