The LP1 main menu offers ways to configure the device for your specific needs. This section of the
document is devoted to the options seen in the main menu.
Edit Group
Track groups are used to manipulate more than one track with a single command. Grouping can be
used to create song sections which can be stopped and started together. Grouping can also be used with
track bouncing to combine several tracks into a single track.
To create a new group:
⚫
Press the MENU button until the main menu is selected. The main menu says “Looperlative LP” on
the top line of the display.
⚫
Turn the knob until the second line of the display reads “Edit Group.”
⚫
Press ENTER
⚫
The top line will read “Select group:”
⚫
Turn the knob to select the group that you wish to edit.
⚫
Press ENTER.
⚫
The top line will now indicate the group number that you selected.
⚫
Press the track buttons for the track that you want in this group. The track buttons are toggle
controls. The first press adds the track, the next press removes the track. The display shows which
tracks are selected on the second line.
⚫
Press ENTER when you have selected the tracks that you want in this group.
⚫
Press MENU to return to normal operating mode.
MIDI Channel
To change the MIDI channel that the LP1 responds to:
⚫
Press the MENU button until the main menu is selected. The main menu says “Looperlative LP” on
the top line of the display.
⚫
Turn the knob until the second line of the display reads “MIDI channel.”
⚫
Press ENTER
⚫
The top line will read “MIDI channel”
⚫
Turn the knob to select the channel that you wish.
⚫
Press ENTER.
Noise Gate
The LP1 contains a built-in noise gate to assist in eliminating noise build up when using overdub. The
default settings are adequate for most circumstances. If you need to adjust it, there are two parameters:
noise gate level and noise gate delay.
Both parameters are adjusted in a similar manner:
⚫
Press the MENU button until the main menu is selected. The main menu says “Looperlative LP” on
