Frequency generator settings
RaMaLoop includes a frequency generator function that allows you to generate
frequencies in the range 0 - 5kHz, higher frequencies are generated as higher
harmonics of this range. At the same time, this menu also contains a timer to
turn off the device after the selected time.
After activating the generator or the shutdown timer, the time and frequency
information are displayed continuously on the main screen. The remaining time
information is updated whenever the displayed frequency is updated, not every
second. Frequencies up to 1000Hz are displayed in Hz, higher frequencies are
displayed in kHz, rounding of higher frequencies is only for imaging, generating
takes place in 1Hz.
You can set up successively up to 5 consecutive programs. Individual programs
allow you to select from preset frequencies in the order of Hz and kHz. For each
selected program, you can manually adjust the desired initial / final frequency
with the START and STOP values, where START is the initial frequency and the
STOP is the final frequency. If the values are the same it is so-called fixed
frequency. Each program also allows you to set the duration.
In addition, the generator allows you to change the direction of startup of the set
programs, turn them on again and set the time for automatic shutdown of the
device.
The preset programs are selected by pressing the OK button on "Program 1"
and gradually down to "Program 5". Use the UP, DOWN, and RIGHT arrows to
select the desired program and confirm with OK. If you have multiple programs
set up, they will automatically start running consecutively from the program that
was first.
1
How to run one program:
1. Enter the "Generator Frequency"
2. Select "Program 1", press OK and select the desired program, the other
items "Program 2-5" set the same way to program number 0
3. If no program meets your requirements, set the desired initial and final
frequency manually using the "Start" and "Stop"
4. Set "Unit start" and "Unit stop" to order, Hz, or kHz, according to your
request for initial and final frequency.
5. Set the length of the program using "Length".