PyroTec™ PRO Hardw are User’s Manual, V1.2
92
RT-MN024-1.2 02/21
Inline filter removal
•
Carefully pierce the old filter side-
ways, using the filter removal tool
(A).
•
Swivel the tool downwards to pry
out the filter.
•
Remove the filter from the DiTi
cone.
•
Clean the DiTi Cone with alcohol and allow to dry.
•
Make sure that the DiTi cone is dry before inserting the inline filter.
Inline filter installation
•
Place the new inline filter on a clean
and even surface.
•
Move the DiTi cone downwards onto
the filter.
Press the filter into the DiTi cone in
such a way that it does not stick out
from the DiTi cone any more.
Test and
Settings
•
To ensure operating readiness, the operator should run the PyroTec™ PRO Software
module “Instrument Warm-Up”. The PyroTec™ PRO software module also contains an
embedded “Inline filter test” in test runs to ensure system functionality.
9.3.2 DiTi Waste Bag
WARNING
Potentially infectious
Instrument parts and solid waste may be contaminated with potentially infectious materi-
als.
•
Follow basic biohazard precautions.
•
Wear appropriate personal protective equipment, such as gloves, lab coats and pro-
tective eye wear
