Longshine LCS-883R-SW2402, User Manual

Page: 3 / 14

Please refer to the following table for LED definition
Type LED Status Operation
Steady Green Power is on Power
Off Power is off
Steady Green Power on diagnostics testing
Off Power on diagnostics test successful
System
Status
Blinking Green Power on diagnostics test fail
Steady Green Connected as 100Mbps 100M
Off Connected as 10Mbps
Steady Green The port is linking up
Blinking Green There is traffic transverses the port
Port 1~24
(10/100Mbps)
LINK/ACT
Off No connection
Steady Green Linking up / Current connecting speed SPEED (10M,
100M, 1000M)
Off All off for Linking down
Steady Green There is traffic transverses the port TX; RX
Off No connection
Steady Amber Full Duplex mode
Off Half Duplex mode
Port 25, 26
(10/100/1000Mbps)
FDX/COL
Blinking Amber Collision
You could use a normal RS-232 cable and connect to the console port on the device. After the
connection, you could run any terminal emulation program (Hyper Terminal, Winterm, Telix, … and
so on) to enter the startup screen of the device. For all the detail software operation, please refer
to “Console Program” session.
DCE
9600 (Fix baud rate)
8 (8 Data bits)
n (No parity checking)
1 (1 stop bit)
None (No flow control)
2
LED Definition
Console Port