LONGER LK4, Instruction Manual

Page: 17 / 27

www.longer3d.com info@longer3d.com
15
(3) Software usage introduction
(4) Detailed software parameters
Layer thickness : 0.1 ~ 0.4mm, high accuracy of 0.1mm, long printing time, generally 0.2mm, low
accuracy of 0.4mm, short printing time.
Wall thickness : set to 0.4mm is very thin, generally set to 1.2 high, it will be firm, and printing
time will increase.
Turn on rollback:
The purpose of thread withdrawal is to prevent the silk from leaking out when
printing quickly, otherwise it will affect the appearance.
Bottom / Top Thickness: To make the top print more perfect, the bottom is flat.
Fill density: If the intensity is not very high, 20% is fine; if the intensity is high, increase it, and the
printing time will increase.
Printing speed
: Generally set between 30-100, the higher the speed, the lower the accuracy.
Printing temperature : depending on the material, it is generally 190 ~ 210 degrees.
Support types : divided into semi-supported and full-supported. Models that have suspensions
relative to the structure usually require additional support, but the surface will be relatively
unsightly after removing the support.
Adhesion platform
: "None" adds nothing; the "bottom edge" edge increases the bottom area;
the "bottom mesh" base makes the model adhere more firmly. In order to make the model stick
to the base better, add a base plate or edge. It is best to add a base and edge to the model with a
small base area.
Diameter : 1.75mm Flow: 100%
3D printer supports gcode format files, so you need to import the STL format model into Changlang 3D slicing
software for slicing operation. To print a fine model, you need to have a deep understanding of the slicing software
that controls the print path. Print out the various models you want, and set each parameter of the machine to the
parameter bar to pop up the corresponding explanation.