Loma IQ3, User Manual

Page: 52 / 144

Installation
■
Setting Up Reject Mechanisms
The conveyor system is supplied with the reject mechanism correctly set up. Normally no
further adjustment should be required.
■
Remote User Interface
The electronic controls for the metal detector are integrated into the search head along with
the user interface, but the user interface can be mounted remotely in it‘s own housing where
access would otherwise be difficult.
■
Installing a Serial Link
In order to use any of the serial link options your detector will require a cable and connector
assembly which facilitates external connection to the on board serial link electronics.
Warnings
The following safety warnings apply when installing an IQ
3
Metal Detector head:
1. LETHAL HAZARD – ELECTRICAL SUPPLIES
2. LETHAL HAZARD – COMPRESSED AIR SUPPLIES
3. NON-IONIZING RADIATION
4. WORKING ON EQUIPMENT
5. REJECT DEVICES
6. EXCESSIVE NOISE
7. HEAVY EQUIPMENT
8. LIFTING THE MACHINE
9. MOVING THE MACHINE
10. CONTAMINANTS
For details see the Safety Warnings section.
The following emergency procedures apply to these procedures:
2. DEALING WITH FIRE.
For details see the Emergency Procedures section.
Receiving and Unpacking
Receiving the machine
■
On receipt of your Loma inspection machine, we recommend that you check the external
packing for any signs of damage.
■
If the external packaging is damaged do not refuse the shipment but make a notation on the
carriers delivery receipt and take pictures of the packaging damage.
■
When moving the machine, please follow the guidance included in the Moving the Machine
section.
Unpacking the machine
■
Remove all packing and retain in case the machine has to be repacked for return.
■
If on unpacking the machine it is subsequently found to be damaged, take further pictures of
the damage and send them to Loma Systems. Loma Systems will then carry out an
investigation, including a review of the applicable carriage terms / Incoterms, to decide what
action is to be taken.
42