QUICK START
Logicube SCSI-
NG User’s Manual
12
value for that drive.
Details on the different screens
found in the Hash operation can
be found in
This mode will hash any connected drive on an active Master or Target port. This mode is Logical Block
Address (LBA) based and will hash a drive based on the number of LBAs.
3.2.1 Step-by-step instructions – Drive Hash
1.
Select
Hash
from the types of operation on the left side.
2.
Tap the
Target
icon and select the drive to be hashed then tap the
OK
icon.
3.
Tap the
Settings
icon to choose the different settings based on the Mode. Details for
4.
Change any of the optional settings (LBA settings or percentage of the drive to be
hashed) if needed.
Optional: Tap Job Info to set the Job Name, Job ID, Operator, Other ID, or Job Notes.
5.
Tap the
Start
icon to start the hash task.
6.
When finished, the status will show “COMPLETED”. At this point, it is recommended to
tap
Reset Task
to reset the task, so the drive bays properly reset and not show as being
used or assigned for other tasks.
3.3 Wipe / Format
The drive connected to the Target bay (right side) can be wiped or formatted. Unless
formatted (with the SCSI-NG), when a drive is wiped, there will be no file system on
the Target drive. The following methods are available in the Wipe menu:
The
Wipe/Format feature
is an option. To find out if this feature
is installed, go to the
Statistics
icon from the navigation menu on
the left and select the
Options
tab. If you need to purchase the
Wipe option, contact our sales team at:
Details on the different screens
found in the Wipe operation can be
found in
Secure Erase
– Sends the SCSI FORMAT command to the drive instructing it to wipe the drive
based on the hard drive manufacturer’s specifications for the SCSI FORMAT command.
Secure erase instructs the SCSI-NG to send a SCSI FORMAT
command to the drive. If the drive supports this command, it
will perform the task based on the manufacturer’s
Summary of Contents for SCSI-NG
Page 12: ......
