User Manual
CBX-1 / CBX-2
4.2.3. Change Displayed Height
This function allows you to change the displayed height, you cannot change the
desk-height. Proceed as follows:
1.
Press the
S
key.
The display reads
S –
.
2.
Press and hold key
desk down
(arrow downwards) for appr. 5
seconds.
The display starts flashing.
3.
Adjust the displayed height with the
desk up
(arrow upwards)
and
desk
down
(arrow downwards) keys.
4.
Press the
S
key.
Now, the displayed height is adjusted to the new height.
Note:
The actual height of the desk cannot be changed with this
procedure. Only the displayed height is being modified.
4.2.4. Manual
Reset
In case of the desk being misaligned, or if you want to to use a pre-configured control
box on an identically constructed desk, you have to carry out an alignment procedure
of the lower end positions.
1.
Press key
desk down
.
Keep holding the downwards key until the desk has reached the
lowest possible position (pre-programmed end position).
2.
Press and hold key
desk down
again.
After appr. 5 seconds the desk slowly starts moving downwards
again until it has reached the absolute end position.
3.
Release key
desk down
. Now, the desk is aligned and ready for
normal operation.
Page 16/29
