Instruction Manual
PRO JOINER
Model F300-2
Preparation continued
C. Set Pressure Foot Over Moulding
1.
Loosen lever adjustment block handle.
2.
Adjust lever adjustment block so pressure foot locates
over middle moulding or where even downward pressure
can be applied (Fig. 10).
3.
Tighten lever.
4.
Due to the many moulding profiles we have included a
black moulding spacer. This is especially useful when the
outside edge of moulding is considerably thinner than
inside (rabbet) edge of moulding. This should help elimi-
nate the joint from opening (Fig. 11)
One nail - the foot should be directly over the nail.
Two nails - the foot should be between the nails.
D. Adjust Foot Height
1.
With moulding now securely clamped, push the vise down
until moulding bottoms out onto V-nail blocks and tighten
vise stop.
2.
Lower lever handle below horizontal.
3.
Adjust pressure foot by turning wheel until it contacts
moulding and handle is below horizontal (Fig. 12).
4.
Release vise stop.
E. V-nail Type
1.
Hardwood nails are used for very hard woods like oak and
maple. Do not use these nails on softwoods.
2.
Softwood nails are used for other woods but can be used
on hardwoods. Test them on hardwoods. If they do not
work, use a hardwood nail.
F. V-nail Size
1.
As a general rule, nail should be at least 1/2 of moulding
thickness.
G. V-nail Quantity
1.
2 V-nails - from 0” to 2” (5cm)
3 V-nails - from 2” (5cm) to 3” (7cm)
Fig. 10
Fig. 11
Angle
Fig. 12
5
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
