Installation
WeftMaster CUT-iT Dornier
www.loepfe.com
37
3.
Press to select desired setting.
4.
Press to confirm desired setting.
5.
Press to confirm desired setting.
ð
The heat cutter type is specified.
ð
WeftMaster CUT-iT Dornier restarts.
5.5
Master/Slave function
When several WeftMaster CUT-iT Dornier devices are connected together, the Master/Slave function is
used and a Master/Slave address set on each unit.
The Master unit controls all Slave units.
n
The Slave devices follow the current setting and mode of the Master.
n
When a Master or a Slave unit detects an error, all units are set to this Error mode and the Master
stops the weaving machine.
The Master unit has address
«0»
, the Slave units have consecutive higher addresses.
n
Address Master unit =
«0»
n
Address 1st Slave-unit =
«1»
n
Address 2nd Slave-unit =
«2»
n
etc. up to
n
Address 32nd Slave-unit =
«32»
Maximum 32 Slave units can be connected.
Not all functions are available for Slave units (missing functions such as Select
program, Set current strength must be carried out on the Master).