5.3 - Cable Management
To make sure that connectors
are not damaged through
pulling them, you need to use
the strain relief.
1. Place the ergometer on its
side. The handlebar will
support the ergometer on the
ground.
2. Remove the strain relief by
pushing the arms in the cavity
inwards.
3. Lead the wires through the
holes in the strain relief as
shown in the picture and place
it back in the ergometer.
Note. There is place for the thick AC cord in the middle and 2 other thinner cables on the sides.
4. Put the ergometer back in upright position.
To connect cables to the ergometer: tilt the device carefully
to the side and leave it resting on the handlebar. Place both
hands on the handle bar and step aside to prevent trapping
of fingers and toes when putting it back upright.
6 - Preparation
11/24
M960900 / VERSION: 1.0 - 2014-09-24
