9 - Cleaning
The belt can be cleaned with a sponge, with little lukewarm water. Allow the belt to dry thoroughly
after cleaning before re-using the treadmill.
9.1 - Cleaning
Before cleaning and other maintenance of any part of the device, first switch off the device and
disconnect it from the mains. The surfaces can be cleaned with a damp cloth and a liquid (non-
abrasive) cleaning product.
General Cleaning
Wipe the device surface down with a cloth moistened with soap water or a disinfectant. The cloth
should not be dripping wet; do not allow liquids to enter the device
Cleaning the Saddle
Clean the saddle with a soft and dry or moist cloth. Disinfectants used should not contain any alcohol.
Cleaning the Upholstery (e.g. couch ergometer)
Wipe the upholstery down with a soft cloth moistened with soap water. The cloth should only be moist
and not dripping wet. If the cleaning agents and disinfectants used are caustic or contain alcohol, they
may damage and/or discolor the upholstery.
If you are not certain about the discolouring effect of a cleaning agent, you may try a little on a part of
the product that is not visible during normal use.
Lode cannot advise a specific cleaning agent, since local recipes may differ.
10 - Control with the Lode Ergometry Manager (LEM)
1. If your device has an RS232 or USB port, connect it directly to the PC LEM is installed on. If your
device has a RJ45 connector plug it with an UTP cable to the special interface connector that was
delivered with your device and to a USB port in your PC.
2. Start Lode Ergometry Manager on your PC
3. If your device has a control unit, select “Terminal”- mode to allow external command. If your device
does not have a control unit the terminal mode is automatically selected. (See for detailed instructions
the user manual of LEM).
12/21
M938900/938905_MANUAL VALIANT 2 CPET (XL) / VERSION: V1.1 - 2016-08-25
