1.
Please Observe the Following
1.1
Emphasized Sections
Warning!
Refers to safety regulations and required safety measures that protect the
operator or other persons from injury or danger to life.
Caution!
Emphasizes what must be done or avoided so that the unit or other property is
not damaged.
Notice
Gives recommendations for better handling of the unit during operation or
adjustment as well as for service activities.
1.2
Safety
Do not touch the nozzle or molten adhesive with bare skin as they are hot -
the operating temperature of the Loctite
®
Hysol
®
175-AIR and 175-AIR-
HT applicators is approximately 400ºF (200ºC). Protective gloves should
always be worn. Careless handling can cause skin burns.
If molten
adhesive comes into contact with the skin immerse the affected area
immediately in plenty of cold water. Seek medical advice if necessary.
In addition to the safety instructions herein, any statutory regulations, local fire
insurance regulations, or other generally valid “regulations for accident
prevention” must be complied with when using this tool.
•
Never use the tool if it is damaged in any way.
•
Do not use this tool in damp rooms, outdoors while it is raining, or where
there is high humidity.
•
Do not use this tool in the vicinity of any heat-sensitive materials, or any
flammable materials, liquids, or gases.
•
Only use extension cables that meet the specification shown in “Technical
data”.
•
Never pull on the tool’s connecting cable.
1.3
Items supplied
Loctite
®
Hysol
®
175-AIR
Pneumatically-driven Hot Melt Cartridge Dispenser, fitted with 383°F (195°C)
thermostat (suitable for standard EVA-based hot melt adhesives)
Valve body airline adapter, Plastic Stand, and Manual
Loctite
®
Hysol
®
175-AIR-HT
Pneumatically-driven Hot Melt Cartridge Dispenser, fitted with 419°F (215°C)
thermostat (suitable for polyamide hot melt adhesives)
Valve body airline adapter, Plastic Stand, and Manual
Summary of Contents for HYSOL 175-AIR
Page 11: ...11 Exploded Diagram ...
