LOAD KING 80-160, Operator'S Manual

Page: 275 / 369

275
Slider Pads
The front bottom slider pad should be checked daily for wear. The remainder of the slider pads should
be checked monthly for wear.
1
1
1
1
1
1
1
1
All the slider pads contain a chamfer (1) on the wearing surface. When this chamfer (1) is worn off, the
slider pad must be replaced.
With boom extended brush grease on areas of boom where wear pads contact is evident.The inside of
the top plate of all sections except the tip section also require grease. This can be applied through the
holes in the side plates and “piled” on top of the next section out just in front of the top rear pads on that
section so that extending the boom to the next hole smears the grease onto the inside of the top plate.
Remember to do both sides.
Grease intervals vary and should be more frequent if noise or jerking of the boom is evident.