LNS QUICK LOAD SERVO S3 T BARFEED, Service Manual

Page: 28 / 152

PROCEDURES
SERVICE MANUAL – QL Servo S3-T
CALIBRATION OF THE LOADING TABLE
INFORMATION
The following conditions must be met to complete this procedure:
•
Bars on the magazine.
•
Loading table in lower position
• Bar feed in
[STOP]
mode
1 Switch to manual mode by pressing the [F2] key.
2 Bring the table to the raised position [F3].
The bar is now opposite the lathe spindle.
3 The remote control prompts the icons [F4] + [FWD] .
Press the [F3] key (approx 3 seconds) until the loading
table calibration icon
[F1]
appears.
4 The loading table calibration icon [F1] appears.
Press the [F1] key.
5 Three icons appear:
[F1] lowers the table
[F2] ESC
(exit without saving)
[F4] raises the table
Each time
[F1]
or
[F4]
is pressed, the vertical position
of the table is changed by 0.25mm. For larger
adjustments, press and hold the button so that the
table moves continuously.
6 Once the required position is reached, press the [F3]
ENTER key to confirm that you wish to recalibrate the
unit to this new position.
7 At this point in time, as the unit's calibration must be modified, the control automatically gives
access to "Part settings – diameter and profile"
The control asks the operator to confirm the set diameter. Use the number keys to enter the bar
diameter which was used to center the table. Use the
[F3] ENTER
key to confirm.