GoMax Smart Vision Accelerator: User Manual
Using GoMax • 29
Accessing Accelerated Sensors
After GoMax starts accelerating a sensor, you can access and configure it in two ways: via web browser
and via SDK applications.
GoMax does not support the PROFINET protocol. For more information on PROFINET, see the
Gocator user manual of your sensor.
Via a Web Browser
When you access an unaccelerated sensor via a web browser, you use the IP address of the sensor
defined in the sensor's networking settings. But after a sensor has been accelerated, you can access it via
the IP address of the GoMax unit and a port defined by GoMax, which are listed in the
Port Settings
section in the
Networking
category on the
Manage
page (for more information on this, see
on page 35). However, the easiest way to access a sensor is via the GoMax interface.
To access a sensor via the GoMax interface:
1.
Using a web browser, connect to the GoMax unit.
2.
On the Manage page, under
Sensors
, in the
Accelerated
list, click the sensor’s serial number to the left.
A page providing a link to the accelerated sensor’s web interface opens in a new tab.
3.
Click the link in the "Accelerated Device Info" page.
The web interface of the accelerated sensor is displayed.
