GoMax Smart Vision Accelerator: User Manual
Adding GoMax to a Sensor System • 21
Mounting
GoMax provides mounting holes on the back and on three sides of the unit. Although you can mount
GoMax using any of these holes and in any orientation, to avoid overheating, LMI recommends the
following:
l
The ventilation holes should be kept free of obstructions. (There are two vents on opposite sides of
the unit.)
l
The larger vent (18 holes with anti-dust mesh) should be at the bottom.
You can mount GoMax units to a DIN rail or directly to a frame.
For details on GoMax's mounting holes, see
Using DIN Rail Clips
LMI provides two DIN rail clips to mount GoMax on a DIN rail. Note the recommended orientation
(smaller vent at the top) in the following illustration:
Mounting Directly to a Frame
You can also mount the GoMax unit directly to a frame. All mounting holes are specified as M4X0.7 - 6H,
with a thread depth of 3.65 mm. The same recommendations for orientation and mounting points (see
above) still apply if you mount GoMax directly to a frame.
