Operations
To ensure safe operation of the FaultChaser, follow the instructions carefully and pay
attention to the warning and caution symbols. Failure to observe warnings can result in
severe injury or death and can damage the unit.
Turning the Unit On/Off
Turn Unit On
•
Press the POWER button to turn the unit ON.
•
The FaultChaser immediately runs a length test when powered ON.
Turn Unit Off
•
Press and hold down the POWER button for two seconds to turn the unit OFF.
The display screen goes blank.
Automatic Power Down
The
FaultChaser
automatically turns off after a period of inactivity to conserve battery
power. The automatic power down feature is dependent on which mode is in use and if
voltage is detected on the cable being tested (see Table 9).
Table 9
.Automatic Power Down.
Mode
Time
Test Mode
1 minute
Loop Testing
3 minutes
Tone Mode
15 minutes
Calibration Mode
1 minute
16
