Fuzzy Joe v1.1
Manufacturers and product names are mentioned solely for circuit identification, and where applicable their trademarks are the
property of their respective owners who are in no way associated or affiliated with the author. No cooperation or endorsement
is implied.
8
Voltage Inverter wiring
Note that
R led1
is
4k7
resistors. You can change this value depending on the type of LED you use but
4k7 is safe enough for almost all LEDs for (-)9V.
It is now time to place your transistors and IC in the sockets if needed. Connect everything, build it in
your enclosure and enjoy your effect!
The sleeve on the output jack is not connected on purpose. Make sure the output jack is in good
electronic contact with the enclosure else you can try and connect the sleeves of the input and
output together. If you test the unit outside of an enclosure you need to connect the output sleeve
to ground!
Ring
Sleeve
Tip
Tip
Sleeve
C
at
hode
(
shor
t
le
g)
Ano
de
(l
on
g
le
g)
R led1
Input
Output
