Listen SoundConnect 2, User Manual

Page: 10 / 27

4 Introduction SoundConnect 2
TM
Manual
Front Panel
The front panel controls allow you to select the
input type for each channel as well as other
settings. Pressing the Setup button will display
other menus to access the various options.
Power Switch
The LED indicator shows when unit is powered
on. The current state of SoundConnect 2 is
stored in memory when it is shut off via the front
panel power switch. These values are recalled
the next time it is turned on.
LCD Display
Parameters are displayed on the top row; values on the bottom.
Channel Settings Mode
This is the default, power up state displayed whenever power
is applied to the unit. Channel Settings Mode provides access
to the parameters that are changed the most: Source and
Gain.
Channel Buttons 1 and 2
Allows you to select the input connector and bias configuration for each
channel. (These buttons are also used to select other parameters in
other Setup Modes.)
Pressing either Channel Button will change the respective channel’s
signal source:

Line In: 1/4” TRS Input, Balanced or Single ended operation

Mic In: Microphone connected to BNC input. No Bias enabled

MicSCM: Microphone connected to BNC input. Biased for constant voltage, e.g.: SCM-2 or SCM-3
microphones, as well as electret capsules. Use with SCM Microphone requires a Microdot to BNC
adapter. See
SCM Microphone with Microdot to BNC Adapter on page 13
.

MicIEPE: Microphone connected to BNC input. Biased for constant current microphones.

MicLemo: Microphone connected to Polarized Lemo input. Bias may be +200V or off.
Also used for SCM Microphone with a Microdot to Lemo adapter. See
SCM Microphone with
Microdot to BNC Adapter on page 13
.
(This option is only available when the optional Lemo board is installed.)

Muted: For use when an output signal is not desired, especially when minimizing noise during
system setup.
Figure 1-1: Front Panel
Line In
-10dB
Mic In
+30dB
Figure 1-2: Channel Settings Mode