Page 70 of 130
Operating instructions
4point light 10W (V 4.58)
8.5.6 Output
Under the menu item “Output” the acquired data are transmitted to the PC via the serial
interface.
1.
Select “Output” from the tomography menu with [
] and [
]
2. Confirm selection with [RET]
Output tomography
File: 3
25.04.2008 09:06:13
Fig. 8.62: Start data transfer to the PC
3.
Select file under “File” with [
] and [
]
4. The status line shows date and time of the measurement
5. Start data transmission with [RET]
Output tomography
Please wait...
Fig. 8.63: Data transfer is running
Data transfer can be cancelled at any time by clicking [ESC]. After data transfer the
program automatically switches back to the tomography menu.
Data transfer to the PC
: Data are transferred to the PC via the serial interface. To receive the
data the program GEOTEST can be used or any other terminal program (e.g. WINDOWS
Terminal or Hyperterminal).
8.5.7 Remote
Under the menu item “RMT” the instrument can be switched to the remote mode.
1.
Select “Rmt” from the tomography menu with [
] and [
]
2. Confirm selection with [RET]
Remote mode
<RET> Activate
<ESC> Cancel
Fig. 8.64: Remote mode
3. Activate remote mode with [RET]
4. Deactivate remote mode with [ESC]