Rev: 01.07.22
Page 5
CCD-0001459
B
A
A
B
Component Descriptions
• A touchpad (Fig. 8), used with programmable controller Power Gear part number 1510000199 / Lippert
part number
, 700155, 700157 or a rocker switch (Fig. 9), used with auto-programmable controller
part numbers (Power Gear / Lippert) 1510000236 /
697096, 700156 and
1510000276 / 366703
(Winnebago). Both types of devices mount to the wall and allow slide-out room movement as well as
provide feedback to the user.
• A specially designed controller that gives the user full control of slide-out room movement, in or out.
The controller has programmable stops that stop the motor when the slide-out room is fully extended or
retracted and the ability to detect faults for ease in troubleshooting.
NOTE:
The programmable controller, which incorporates use of a touchpad, is initially programmed once
at installation. It is reprogrammed by an OEM-authorized dealer only if stops must be reset due to
fault codes or to change the initial settings. With the auto-programmable controllers, those that
connect to a rocker switch, the stops are automatically programmed each time the slide-out room is
used.
• Vertical channel with 12V DC gear motor and gear rack arms that mount into the side wall opening and
slide-out room.
• Harnesses to connect the rocker switch or touchpad and the motors to the controller.
• A manual override that allows extension / retraction of the slide-out room in the event of a loss of power.
• Floor rollers (not supplied by Lippert ) that support the slide-out room's weight while extending and
retracting the slide-out room. Only floor rollers approved by Lippert can be used with the system. Contact
Lippert for recommended rollers.
Fig. 8
Fig. 9
