8
lippert.com
432-LIPPERT (432-547-7378)
Rev: 09.29.21
Tire Linc
®
AU
Tyre Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004069
Use Smart Phone to Pair Sensors to Repeater
NOTE:
If a wrong caravan type is chosen or there is a new
caravan configuration, see Troubleshooting section for
factory reset�
The OneControl BT app on the smart phone will indicate
in specific order which tyre the stem sensor cap should be
installed: Front Left, Rear Left, Front Right, Rear Right, etc�
1.
Have stem sensors
(Fig.13)
available to install on the tyre
stems and remove any existing stem caps from the tyres�
NOTE:
If using the lock nuts as a theft deterrent, add the
lock nuts to the tyre stems but make sure there is room to
add the sensors� Lock nuts will be tightened later� The lock
nuts are optional and are not required to be installed�
2.
Pair stem sensors to the repeater as follows:
A.
Select the Learn Sensors arrow
(Fig.15A)
in the TYRE
PRESSURE app screen if not having done so already� The
app will display a list of tyres with instructions to screw the
first stem sensor onto the Front Left tyre stem
(Fig.16)
�
B.
Install a stem sensor onto the tyre stem in the proper
sequence
(Fig.16)
and wait for the smart phone to indicate
the sensor was found
(Fig.17A)
�
NOTE:
It may take up to 90 seconds for the sensor to
awake and be found�
C.
If the sensor is not seen within 90 seconds, unscrew the
sensor from the tyre stem, wait approximately 10 seconds
and then reinstall the sensor� Do not proceed to install any
other sensors until the app shows the sensor found�
D.
After the sensor has been found, the app will indicate
the next tyre sensor to be paired
(Fig.17B)
�
3.
Repeat steps 2B, 2C and 2D until all sensors are
learned
(Fig.18)
�
Fig.15
Fig.16
A