7
574-537-8900
Rev: 05.01.20
Tire Linc
®
Tire Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003848
Use Smart Phone to Pair Sensors to Repeater
NOTE:
If a wrong trailer type is chosen or there is a new
trailer configuration, see Troubleshooting section for
factory reset.
The OneControl app on the smart phone will indicate in
specific order which tire the stem sensor cap should be
installed: Front Left, Rear Left, Front Right, Rear Right, etc.
1.
Have Stem Sensors
(Fig.10)
available to install on the tire
stems and remove any existing stem caps from the tires.
NOTE:
If using the lock nuts as a theft deterrent, add the
lock nuts to the tire stems but make sure there is room to add
the sensors. Lock nuts will be tightened later. The lock nuts
are optional and are not required to be installed.
2.
Pair stem sensors to the repeater as follows:
A.
Select the Learn Sensors button
(Fig.12A)
in the TIRE
A
Fig.13
PRESSURE app screen. The app will display a list of tires
with instructions to screw the first stem sensor onto the
Front Left tire stem
(Fig.13)
.
B.
Install a stem sensor onto the tire stem in the proper
sequence
(Fig.11)
and wait for the smart phone to indicate
the sensor was found
(Fig.14A)
.
NOTE:
It may take up to 30 seconds for the sensor to
awake and be found.
C.
If the sensor is not seen within 30 seconds, unscrew the
sensor from the tire stem, wait approximately 10 seconds
and then reinstall the sensor. Do not proceed to install any
other sensors until the app shows the sensor found.
D.
After the sensor has been found, the app will indicate
the next tire sensor to be paired
(Fig.14B)
.
3.
Repeat steps 2B, 2C and 2D until all sensors are
learned
(Fig.15)
.
Fig.12
