3
574-537-8900
Rev: 05.01.20
Tire Linc
®
Tire Pressure & Temperature
Monitoring System 2.0
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003848
Installation of Repeater Dock
Install Tire Linc on a non-prepped trailer as follows:
NOTE:
Non-prepped trailers do not have a repeater dock
installed; prepped trailers do. If a repeater dock is installed,
go to Installation and Setup section.
1.
Locate a mounting area inside the trailer that allows
connection of the Tire Linc repeater dock
(Fig.1A)
to the
unit’s power source without creating a strain on the
completed connection.
2.
Vertically orient the repeater dock and secure it to the
wall with two #8 x
3/4
” self-tapping pan head screws
(Fig.1B)
(not supplied).
3.
Make sure power to the trailer is off, then connect the
repeater dock’s red power wire
(Fig.1C)
and black ground
wire
(Fig.1D)
to system power and ground as follows:
A.
If necessary, use wire strippers to expose enough bare
wire to make a good connection.
B.
Use appropriate electrical connectors to create good
connections.
C.
Make sure there is a 15A maximum circuit protection
placed in-line between the power supply and the
repeater dock.
Fig.1
B
A
C
D
Resources Required
• OneControl
®
app
• Cordless or electric drill or screw gun
• Appropriate drive bits
• #8 x
3/4
” self-tapping pan head screws
• Wire strippers
• Appropriate electrical connectors
