Rev: 07.18.18
Page 4
CCD-0001653
Adjust Transport Lock
1.
If adjustment is required, loosen the two bolts (Fig. 2A) on both sides of the transport lock. This allows
for up to a
1/2"
of adjustment either way in the latch mechanism.
2.
After the transport lock has been correctly positioned, tighten the bolts.
A
Fig. 2
A
Fig. 3
3.
After the transport lock has been adjusted, test its functionality by shaking the step assembly to
simulate road vibration.
4.
Engage and disengage the transport lock (Fig. 3A) to make sure the latch flanges do not scrape against
the doorframe.
NOTE:
To make minor adjustments, it may be necessary to loosen the original two fasteners installed in
the hinge plate during placement of the assembly in the doorframe. Refer to step 3 in the "Place
Assembly Inside Doorframe" section.
Do not attempt to lock the step in place, as the latching mechanism may need to be adjusted to the
proper left-right orientation and tightened in position before using the transport lock. Attempting
to engage the transport lock without proper adjustment may cause damage to the doorframe or step
assembly.
Do not overtighten the bolts. Overtightening the bolts may damage the threads in the sheet metal or
cause the bolt heads to break off.