7
lci1.com
574-537-8900
Rev: 03.19.18
Solera
®
Universal Hardware
Manual Awning to
Solera Hybrid Awning
(For Aftermarket Applications)
CCD-0001269
Carefree Manual Awning to Solera Hybrid Awning
NOTE:
All screws supporting the awning assembly
MUST
have a backer within the structure of the wall of the unit.
NOTE:
This manual will refer to the “drive side” and “idler
side” throughout for various instructions. The “drive side” is
the right hand side of the awning when facing the awning
from the exterior of the unit. The “idler side” is the left
hand side of the awning when facing the awning from the
exterior of the unit.
1.
Unlock the travel locks, move the cam lock to the roll out
position and extend the awning approximately 12”.
2.
Insert a cotter pin
(Fig.12A)
into the end cap
(Fig.12B)
at each end of the awning.
NOTE:
Some Carefree systems do not have a hole on the
drive end cap for the cotter pin. In this instance, the cam
lock
MUST
remain in the roll out position until it is time to
release the tension in the springs.
Fig.12
A
B
NOTE:
Some Carefree systems are equipped with a cam lock
assist on the drive side of the awning. If equipped, remove the
cam lock assist
(Fig.13B)
from the lock pin
(Fig.13A)
, making
sure the cam lock remains in the roll out position.
A
B
Fig.13
3.
With an assistant holding the roll tube
(Fig.14A)
, remove
the fastener securing the drive head
(Fig.14B)
to the
support arm.
A
B
Fig.14
4.
Separate the drive head from the support arm and
secure the support arm to the unit in the travel position.