Rev: 11.21.2014
Page 8
Euro Loft Bed Lift by Project 2000 Owner's Manual
11.
Place the limit switch correctly, making sure the bed locates against it perfectly when it comes to its
highest position.
NOTE:
For bed lifting systems where the highest position is right under the vehicle roof or when the highest
position more than 1500 mm from the floor, it is necessary to mount at least 2 opposed safety belts
with internal micro-switch with normally closed contact.
NOTE:
The micro-switch must be connected in series with the limit switch. There must be at least 2 opposed
safety belts.
12.
Bring the bed lifting system to its lowest position, making sure the stabilizer runners are in a perfectly
vertical position and will not jam.
13.
Fix the stabilizer runners with suitable screws (we recommend at least 3.8x20 screws) in the middle
channel of the runner at a maximum distance of 10" from each other.
NOTE:
Make sure the screw head does not protrude too much, otherwise it will hit and damage the
stabilizer. Adjust the stabilizer and fix the m4x6 screws with some “soft” thread-locker.
14.
Then install the electrical components (Fig. 7) and program the system as illustrated in the installation
and programming manual (ONLY AVAILABLE FOR SERVICE CENTERS)
NOTE:
It is forbidden to use the bed while the vehicle is running, as the bed must be locked with safety
belts.
NOTE:
Each bed lifting system model was designed and developed to reduce or eliminate any risks related
to cutting and tangling. The installer must however mount the system avoiding any risk factors/
elements such as sharp edges, curls, etc.
15.
After finishing installation, make sure the bed lifting system has no clearances and movements and the
bed is parallel to the floor.
NOTE:
In the event it is necessary to operate the bed lift system manually through the handle, it is
compulsory to carry this operation without disconnecting the wires from the motor unit to the
control unit.
NOTE:
Never disconnect the wires from the motor unit to the control unit for a manual start of the bed lift
system.
Electrical
•
With mechanical encoder.
The circuit board is a controlling device with:
•
DC 12 V power, maximum 25A.
•
Free, normally closed contact end-of-stroke signal input.
•
DC 12 V, maximum 25 A motor output, with polarity control.
Fig. 1