Rev: 11.21.2014
Page 13
Euro Loft Bed Lift by Project 2000 Owner's Manual
The diagram in Fig. 6 summarizes all of the connections between the board and the other items that should be
established in order for the system to work correctly.
The motor connections (pin 3 and 7 of the 8-pole connector) and power connections (pins 4 and 8 of the 8-pole
connector) must be carried out exactly as shown in the picture, be sure to use cables with a minimum section of
11/64".
Follow the instructions provided with the bed lifting system (wiring diagram).
Comply with current CEI regulations during the installation operation.
The Manufacturer provides a set of standard cables for installation with the bed lifting system. After electric
installation it will be possible to start up and test the system.
The Manufacturer shall be held harmless for any bed lifting system malfunctioning caused by not having perfectly
functioning electric system connections or to a wrong installation on the vehicle.
Fig. 7
The bed moves vertically in a specific structure developed to this purpose and its stroke is limited by two ends:
•
On the upper side, the stroke is limited by an end-of-stroke sensor;
•
On the lower side, the limit is represented by the lowest position set, by means of regulating the end-of-stroke
located on the mechanical encoder.
The bed can be lifted or lowered through activation in “ON” position of the key switch located on the panel and
by pressing the arrow-shaped switches on the front panel. When pressing the UP (arrow up) switch the bed will be
lifted and it will go down when pressing the DOWN switch.
Two green LED-lights are located on the controller panel and they will simultaneously switch on. During movement
of the bed, only the LED Corresponding to the direction of travel will be turned on.
The bed will be moving until you keep pressing the switch and it will stop when:
•
The switch is released.
•
A pre-set stop position is reached.
•
The bed is being lifted and the end-of-stroke position is reached.
The bed will move by pressing one of the switches again, unless one of the following conditions is detected:
•
The bed is in the end-of-stroke position and the UP switch is kept pressed.
•
The bed is in the lower programmed position and the DOWN switch is kept pressed.