Rev: 08.31.20
Page 4
CCD-0002697
Installation
1.
Install controller in watertight location.
2.
Connect 12V power and ground to the board.
NOTE:
Use a 30A circuit at the power converter or connect on the converter side of the battery disconnect
with a 30A mini breaker in line prior to the X1 controller. Make sure to follow RVIA guidelines for
wire gauge and fusing.
3.
Using the provided harnesses, make connections for each input and output used. Each of these is
described below. Refer to figure 1.
A.
CAN: Data cable connections that link each module in the OneControl system together. A
terminating resistor must be placed in the X1 board if no other modules are used.
B.
Lockout: Provides in-transit lockout of moving features. Towable input from brake light/turn signal
wire.
C.
Configurable Inputs (Fig. 2): The X1 has 16 configurable inputs. These inputs are configured to be
used with manual switches for both reversing and latching outputs. Any one of the inputs can also
be configured as a DSI fault input if needed for a gas water heater.
D.
Low Current (LC) Latching Outputs (Fig. 3): Connections are available for four low current (5A
maximum) latching outputs. This is a +12V output. Using the wiring diagram or color-coded label
on the lid, make all connections for each output used. Each output used must be assigned and
named using the X Series Configurator (Fig. 4).
E.
Low Current (LC) Reversing Outputs (Fig. 1, #1 and #2 ): Connections are available for two low
current reversing outputs. Each output uses a quick slide connector for Extend and Retract. Using
the wiring diagram or color-coded label on the lid, make all connections for each output used.
Power
Ground
CAN
Terminating Resistor
Fig. 1
Configurable Inputs
16 Pin Switch Harness
Lockout
5A Latching Outputs
Latching Output Harness
#1 LC REV
Extend
Retract
Extend
Retract
#2 LC REV
#3 HC REV
#4 HC REV
#5 HC REV
Extend
Retract
Extend
Retract
Extend
Retract
