Lippert Components OneControl HVAC Control 2.0, Oem Installation Manual

Page: 8 / 14

Rev: 11.09.20
Page 8
CCD-0001450
All user control and input is accomplished using the OneControl mobile application, OneControl tablet or
OneControl Touch Panel (OCTP).
NOTE:
When using the HVAC system, all of the controls you would normally find on your thermostat will be
located in the HVAC icon on your OneControl Touch Panel.
Power On/Off
1.
The device can be powered on or off using the button on the front of the device (Fig. 9).
NOTE:
It will take a few moments to start up and load the system.
Fig. 9
Fig. 11 Fig. 10
A
Operation
Adhere to all local and national codes. Disconnect all external A/C power to the unit before
installing, removing, or cleaning.
2.
To enter or exit sleep mode, press and release the power button.
Touch Panel
1. Locate “OneControl" control panel (Fig. 10).
2.
Press the icon of the system you wish to operate.
3.
Push the system “Home” button (Fig. 10A) to return to the OneControl home screen.
NOTE:
The touch panel will show icons representing the devices that are currently connected to the
"OneControl" system (Fig. 11) via CAN bus.